CRANKSHAFT POSITION SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

      Note

      If reusing the crankshaft position sensor, be sure to inspect the O-ring.

    2. Install the crankshaft position sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the crankshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or does not move out of place during installation.

    3. Connect the crankshaft position sensor connector.

  2. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY (for 2WD)

    Click here

  3. INSTALL TRANSMISSION UNDER COVER (for 2WD)

    Click here

  4. INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET (for AWD)

    Click here

  5. INSTALL NO. 2 MANIFOLD STAY (for AWD)


    1. Install the No. 2 manifold stay with the 2 bolts and nut.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  6. INSTALL FRONT ENGINE MOUNTING INSULATOR (for AWD)

    Click here

  7. CONNECT FRONT FRAME ASSEMBLY (for AWD)

    Click here

  8. INSTALL ENGINE AND TRANSMISSION ASSEMBLY (for AWD)

    Click here