CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side television camera assembly removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Side television camera view adjustment | Panoramic view monitor system | Click here for Initialization Click here for Calibration |
Tech Tips
Use the same procedure for the RH and LH side.
The following procedure is for the LH side.
PROCEDURE
REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
REMOVE DOOR ARMREST COVER
REMOVE COURTESY LIGHT ASSEMBLY
REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
REMOVE OUTER MIRROR PROTECTOR
Remove the 2 outer mirror protectors.
REMOVE OUTER MIRROR INSTALL HOLE COVER
w/o Panoramic View Monitor System:
Disconnect the connector.
Disengage the 3 clamps.
w/ Panoramic View Monitor System:
Disconnect the 2 connectors.
Disengage the 3 clamps.
Remove the 2 screws.
Disengage the 2 claws to remove the outer mirror install hole cover.
REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
Remove the 3 nuts.
Disengage the claw and 2 guides, and remove the outer rear view mirror assembly.