Click here

DRIVE BELT REMOVAL

Click here
Click here

PROCEDURE


  1. Click here

    REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. Click here

    REMOVE LOWER RADIATOR AIR DEFLECTOR

    Click here

  3. Click here

    REMOVE RADIATOR COVER PLATE

    Click here

  4. Click here

    REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  5. Click here

    REMOVE NO. 1 AIR CLEANER INLET

    Click here

  6. Click here

    REMOVE V-RIBBED BELT


    1. Prepare a clean durable piece of cloth and fold it several times.

      Tip:

      Fold the cloth several times to make it thicker.

    2. B004RQY

      Pass the cloth under the V-ribbed belt between the crankshaft pulley assembly and engine water pump assembly as shown in the illustration.

      Note:

      Position the cloth so that the part closest to the engine is longer.

    3. B004X39

      Slightly rotate the crankshaft pulley assembly clockwise so that the cloth is pulled between the V-ribbed belt and engine water pump assembly.

      Note:

      Do not allow the cloth to be pulled further than the top center of the engine water pump assembly.

    4. B004RBJ

      Fold the cloth over the V-ribbed belt and pull it as shown in the illustration while gradually rotating the crankshaft pulley assembly clockwise.

      Note:

      Pull the cloth until the upper part of the V-ribbed belt comes off the engine water pump assembly.

    5. B004SA7

      Check that the upper part of the V-ribbed belt is off the engine water pump assembly, then rotate the crankshaft pulley assembly clockwise to remove V-ribbed belt.