CAUTION / NOTICE / HINT
Tech Tips
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
PROCEDURE
PRECAUTION (w/ Power Window)
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)
Note
When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
REMOVE REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)
REMOVE REAR DOOR NO. 1 STIFFENER CUSHION
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
REMOVE DOOR ASSIST GRIP COVER LH
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
REMOVE REAR DOOR SERVICE HOLE COVER LH
REMOVE REAR DOOR GLASS RUN LH
REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
REMOVE REAR DOOR QUARTER WINDOW GLASS LH
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
REMOVE REAR DOOR BELT MOULDING LH
*1 | Protective Tape |
*2 | Claw A |
Put protective tape around the rear door belt moulding.
Detach the 7 claws and remove the rear door belt moulding.
Tech Tips
If either of the claws labeled A is damaged, replace the rear door belt moulding with a new one.