THROTTLE BODY REMOVAL

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DRAIN ENGINE COOLANT

    Click here

  5. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A0058PP

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A00541V

      Disconnect the mass air flow meter connector.

    2. Detach the wire harness from the 2 clamps.

    3. A0057A6

      Disconnect the 2 clamps.

    4. A0056I0

      Disconnect the ventilation hose.

    5. Loosen the band and remove the air cleaner cap.

  7. REMOVE THROTTLE BODY ASSEMBLY


    1. A0054SW

      Disconnect the throttle body connector and 2 water hoses.

    2. A005989E02
      Text in Illustration
      *a for Type A
      *b for Type B

      for Type A:

      Remove the 2 bolts, 2 nuts and throttle body.

    3. for Type B:

      Remove the 4 bolts and throttle body.

    4. Remove the gasket.