CAUTION / NOTICE / HINT
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).
DISABLE BRAKE CONTROL (for LHD)
REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)
Use the same procedure as for LHD (Click here).
REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
DISABLE BRAKE CONTROL (for RHD)
REMOVE FRONT WHEEL
SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
REMOVE FRONT DISC
INSPECT FRONT AXLE HUB BEARING LOOSENESS
Using a dial indicator, check for looseness near the center of the front axle hub.
Maximum looseness |
---|
0.05 mm (0.00197 in.) |
Ensure that the dial indicator is set perpendicular to the measurement surface.
Keep the magnet of the dial indicator away from the front speed sensor.
If the looseness exceeds the maximum, replace the front axle hub bearing.
INSPECT FRONT AXLE HUB RUNOUT
Using a dial indicator, check for runout on the surface of the front axle hub outside the hub bolts.
Maximum runout |
---|
0.05 mm (0.00197 in.) |
Ensure that the dial indicator is set perpendicular to the measurement surface.
Keep the magnet of the dial indicator away from the front speed sensor.
If the runout exceeds the maximum, replace the front axle hub sub-assembly and front axle hub bearing.
INSTALL FRONT DISC
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
INSTALL FRONT WHEEL
103 N*m | 1049 kgf*cm | 76 ft.*lbf |
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Connect the cable to the negative (-) auxiliary battery terminal (Click here).
Connect the reservoir level switch connector.
Clear the DTCs (Click here).
INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)
Use the same procedure as for LHD (Click here).