PROCEDURE
INSPECT TIRES
Check the tires for wear and proper inflation pressure.
Specified Pressure (When Tire is Cool) (for Europe) | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
*1: For EU (Member States of European Union)
*2: Except EU (Member States of European Union)
*3: For driving at over 160 km/h (100 mph)
Specified Pressure (When Tire is Cool) (for China) | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
Specified Pressure (When Tire is Cool) (for Middle East) | |||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
*: For driving at over 160 km/h (100 mph)
Specified Pressure (When Tire is Cool) (for Australia) | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
Specified Pressure (When Tire is Cool) (for General Export) | |||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
*: For driving at over 160 km/h (100 mph)
Tire pressure adjustment method when warm (w/ Tire Pressure Warning System):
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Adjust the tire pressure so that the displayed value is equal to the set pressure.
Perform initialization and check that initialization completes.
Check and record the value of the Data List item "Temperature in Tire". (Ts)
Check and record the ambient temperature during tire pressure adjustment. (Tm)
Readjust the tire pressure according to the difference between the tire internal temperature (Ts) and the ambient temperature (Tm). (P)
Tech Tips
Tire internal temperature: Ts, Ambient temperature: Tm, Tire pressure readjustment value: PP = (Specified Pressure) + (Ts - Tm)
Check the pressure adjustment value with the Data List item "Tire Inflation Pressure".
Note
Check the tire pressure warning system description for the relationship between the inflation pressure and tire pressure warning pressure.
Using a dial indicator, check the runout of the tires.
Tire runout |
---|
3.0 mm (0.118 in.) or less |
Tech Tips
Remove the wheel assembly from the vehicle, and measure the wheel assembly alone.
ROTATE TIRES
*a | Front of the Vehicle |
Rotate the tires as shown in the illustration.
INSPECT WHEEL BALANCE
for Steel Wheel Type:
Check and adjust the off-the-car balance.
Standard Imbalance After Adjustment |
---|
12 g (0.0265 lb) or less |
Tech Tips
If necessary, check and adjust the on-the-car balance.
for Aluminum Wheel Type:
Check and adjust the off-the-car balance.
Tire Size | Standard Imbalance After Adjustment |
---|---|
285/65R17 116H | 7.5 g (0.0165 lb) or less |
285/60R18 116V | 7.0 g (0.0154 lb) or less |
285/50R20 112V | 6.5 g (0.0143 lb) or less |
Note
Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be attached.
Do not touch the adhesive surface of the tape.
Attach a sticking-type balance weight to the flat surface (A) shown in the illustration.
Width (A) |
---|
20 mm (0.787 in.) |
Push the balance weight firmly so that it securely adheres to the position.
Do not reuse the balance weight.
Tech Tips
If necessary, check and adjust the on-the-car balance.
INSPECT FRONT AXLE HUB
INSPECT REAR AXLE SHAFT