PROCEDURE
REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)
OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
REMOVE FRONT WHEEL
DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
REMOVE FRONT DISC
REMOVE FRONT AXLE HUB GREASE CAP LH
INSPECT FRONT AXLE HUB BEARING LOOSENESS
Using a dial indicator, measure the looseness near the center of the axle hub.
Maximum looseness |
---|
0.05 mm (0.00197 in.) |
Note
Ensure that the dial indicator is set at a right angle to the measurement surface.
If the looseness exceeds the maximum, replace the axle hub.
INSPECT FRONT AXLE HUB RUNOUT
Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.
Maximum runout |
---|
0.08 mm (0.00315 in.) |
Note
Ensure that the dial indicator is set at a right angle to the measurement surface.
If the runout exceeds the maximum, replace the axle hub.
INSTALL FRONT AXLE HUB GREASE CAP LH
INSTALL FRONT DISC
CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
INSTALL FRONT WHEEL
MEASURE VEHICLE HEIGHT (w/ KDSS)
CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)