CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.
Tech Tips
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
REMOVE REAR SEAT ASSEMBLY (for LH Side)
REMOVE REAR SEAT ASSEMBLY (for RH Side)
REMOVE FRONT DOOR SCUFF PLATE
DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Disengage the 3 claws to remove the lap belt outer anchor cover.
Remove the bolt to disconnect the floor anchor part of the front seat outer belt assembly.
REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY
REMOVE CENTER PILLAR UPPER GARNISH
REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt and shoulder anchor.
Using a screwdriver with its tip wrapped in protective tape, release the locking button.
Disconnect the pretensioner connector.
*1 | Locking Button |
*a | Protective Tape |
Remove the 2 bolts.
Disengage the 2 hooks to remove the front seat outer belt assembly.