SEAT POSITION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the seat position airbag sensor removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	for 8GR-FKS: Click here for V35A-FTS: Click here
	Memorize steering angle neutral point	LKA/LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic View Monitor system	Click here
	Initialize Rear Door Sunshade System	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here

*: When performing learning using the GTS.
Click here Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
REMOVE FRONT SEAT ASSEMBLY LH

Click here
REMOVE SEAT POSITION AIRBAG SENSOR
1. Disconnect the connector.
2. Using a T30 "TORX" socket wrench, remove the "TORX" bolt and washer.
  
  Note
  
  Do not reuse the "TORX" bolt.
3. Remove the seat position airbag sensor together with the seat slide position sensor protector as shown in the illustration.
  
  Tech Tips
  
  It may be slightly difficult to remove due to the magnetic force.
4. Remove in this Direction
  
  Slide the seat slide position sensor protector and remove it.
5. Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor from the bracket.
  
  Note
  
  Do not reuse the "TORX" bolt.
  
  Tech Tips
  
  There is a washer between the seat position airbag sensor and the bracket.