BRAKE PEDAL(for RHD) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE STEERING COLUMN ASSEMBLY

    Click here

  3. DISCONNECT BRAKE PEDAL SUPPORT ASSEMBLY


    1. B006CV5

      Disconnect the brake pedal load sensing switch connector.

    2. Disconnect the wire harness clamp from the brake pedal support assembly.

    3. B006CLA

      Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.

  4. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY

    Click here

  5. REMOVE BRAKE PEDAL RETURN SPRING


    1. B006E6M

      Remove the brake pedal return spring from the brake pedal support assembly.

  6. REMOVE STOP LIGHT SWITCH ASSEMBLY

    Click here

  7. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

    Click here

  8. REMOVE PUSH ROD PIN


    1. B006D7X

      Remove the clip and push rod pin.

  9. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

    B006AP4

    1. Remove the 2 clips from brake pedal support assembly.

    2. Remove the 4 nuts and brake pedal support assembly.

  10. REMOVE BRAKE PEDAL PAD


    1. Remove the brake pedal pad from the brake pedal support assembly.