REAR SUNSHADE ASSEMBLY(for Quarter Panel) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear side window curtain assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	LKA/LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here

*: When performing learning using the GTS.
Click here Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

Click here

REMOVE REAR SIDE WINDOW CURTAIN ASSEMBLY LH

Bolt

Connector

Remove the 3 bolts.
Detach the clamp and disconnect the connector.
Detach the clip.
Pull in the removal direction (1) shown in the illustration to tilt the rear side window curtain assembly LH toward the center of the vehicle.

Pull in the removal direction (2) shown in the illustration to pull out the storage tube and remove the rear side window curtain assembly LH.

*1	Storage Tube	-	-
	Remove in this Direction (1)		Remove in this Direction (2)

	Bolt
	Connector