ROOF RACK(w/ Rear No. 2 Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during roof rack removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point LKA /LDA system

Click here

Intelligent clearance sonar system*1
Pre-crash safety system

Lighting system (EXT)


  • Cornering lights
Adaptive high beam system
Parking assist monitor system (w/ Parallel parking assist function)

Click here

Parking assist monitor system (w/o Parallel parking assist function)

Click here

Panoramic view monitor system

Click here

Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

*1: When performing learning using the Techstream.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B007WTA

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

    Click here

  2. REMOVE ROOF RACK ASSEMBLY LH


    1. B007XN1C01
      B007ZL6 Protective Tape

      Apply protective tape around the roof rack assembly LH.

    2. B007X7I

      Remove the 4 nuts.

    3. B007YKPC01
      B007Z37 Remove in this Direction

      Disengage the claw as shown in the illustration to remove the roof rack assembly LH.

  3. REMOVE REAR ROOF RACK LEG CUSHION LH


    1. B007Y5RC01
      B007Z37 Remove in this Direction

      Disengage the 2 claws and guide as shown in the illustration to remove the rear roof rack leg cushion LH.

  4. REMOVE FRONT ROOF RACK RETAINER LH


    1. B007YSAC01
      B007Z37 Remove in this Direction

      Disengage the claw as shown in the illustration to remove the front roof rack retainer LH.

  5. REMOVE FRONT ROOF RACK LEG CUSHION LH


    1. B007Z96C01
      B007Z37 Remove in this Direction

      Disengage the 2 claws and guide as shown in the illustration to remove the front roof rack leg cushion LH.

  6. REMOVE NO. 2 ROOF CARRIER PROTECTOR


    1. Remove the No. 2 roof carrier protector as shown in the illustration.

      B007ZXMC01
      B007Z37 Remove in this Direction - -

  7. REMOVE NO. 1 ROOF CARRIER PROTECTOR

    Tech Tips

    When removing the No. 1 roof carrier protector, heat the roof rack assembly using a heat light.

    Standard
    Item Temperature
    Roof Rack Assembly 40 to 60°C (104 to 140°F)

    CAUTION:


    • Do not touch the heat light and heated parts, touching the heat light may result in burns.

    • Touching heated parts for a long time may result in burns.

    B007Y0LC23
    *a Heated Part
    *b Heat Light

    Note

    Do not heat the roof rack assembly excessively.


    1. Remove the No. 1 roof carrier protector.

      B007WQ5

  8. REMOVE ROOF CARRIER SEAL

    Tech Tips

    When removing the roof carrier seals, heat the roof rack assembly using a heat light.

    Standard
    Item Temperature
    Roof Rack Assembly 40 to 60°C (104 to 140°F)

    CAUTION:


    • Do not touch the heat light and heated parts, touching the heat light may result in burns.

    • Touching heated parts for a long time may result in burns.

    B007Y0LC23
    *a Heated Part
    *b Heat Light

    Note

    Do not heat the roof rack assembly excessively.


    1. Remove the 4 roof carrier seals.

      B007WLS