REAR SEAT INNER BELT ASSEMBLY(for LH Side) REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat inner belt assembly removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | LKA/LDA System | |
| Pre-Crash Safety System | |||
| Lighting System (EXT)
|
|||
| Adaptive High Beam System | |||
| Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) | Stop and start system | ||
| Memorize steering angle neutral point | Parking Assist Monitor System (w/ Parallel Parking Assist Function) | ||
| Parking Assist Monitor System (w/o Parallel Parking Assist Function) | |||
| Panoramic View Monitor System | |||
| Initialize back door lock | Power door lock control system | ||
| Reset back door close position | Power back door system |
CAUTION:
-
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
-
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
-
REMOVE REAR SEAT ASSEMBLY LH
-
REMOVE REAR CENTER SEAT INNER BELT ASSEMBLY
-
REMOVE REAR SEAT COVER CAP LH (for Manual Seat)
-
REMOVE NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)
-
REMOVE POWER SEAT SWITCH ASSEMBLY (for Power Seat)
-
DISCONNECT SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
-
REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
-
REMOVE REAR SEAT INNER BELT ASSEMBLY LH
-
w/ Seat Belt Warning System:
-
Disengage each clamp.
-
-
Remove the bolt and rear seat inner belt assembly LH.
-