VACUUM PUMP(for V35A-FTS) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE V-BANK COVER SUB-ASSEMBLY

   Click here

2. REMOVE RADIATOR COVER PLATE

   Click here

3. REMOVE HOOD TO COWL TOP SEAL

   Click here

4. REMOVE CENTER NO. 2 COWL TOP VENTILATOR LOUVER

   Click here

5. REMOVE FENDER APRON BRACE SUB-ASSEMBLY RH

   Click here

6. DRAIN COOLANT (for Intercooler)

   Click here

7. REMOVE THROTTLE W/MOTOR BODY ASSEMBLY

   Click here

8. DISCONNECT FUEL VAPOR FEED PIPE

   Click here

9. REMOVE V-BANK COVER BRACKET

   Click here

10. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

    Click here

11. DISCONNECT ENGINE WIRE HARNESS

    Click here

12. DISCONNECT INLET HEATER WATER HOSE

    Click here

13. DISCONNECT OUTLET HEATER WATER HOSE

    Click here

14. REMOVE NO. 1 WATER BY-PASS TUBE

    Click here

15. REMOVE WIRING HARNESS CLAMP BRACKET

    
    

    1. 

       Detach the clamp.

    2. Remove the bolt and wiring harness clamp bracket.

16. REMOVE VACUUM PUMP ASSEMBLY

    
    

    1. 

       *a	Retainer
       	Pinch
       	Pull off

       Pinch the retainer of the connector, and then pull the connector off of the vacuum pump assembly.

       Note

       Be sure to disconnect the connector by hand.

    2. 

       Remove the 3 bolts and vacuum pump assembly from the engine assembly.

    3. 

       Remove the No. 1 vacuum pump O-ring.