SFI SYSTEM (w/ Dual VVT-i) PROBLEM SYMPTOMS TABLE

Tech Tips


  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.

SFI System
Symptom Suspected Area See page
Engine does not crank (Does not start) Battery

Click here

Starter

Click here

Starter relay

Click here

Park/neutral position switch assembly (for A/T)

Click here

VC output circuit

Click here

No initial combustion (Does not start) ECM power source circuit

Click here

Crankshaft position sensor

Click here

Camshaft position sensor

Click here

Ignition system

Click here

Fuel pump control circuit

Click here

Fuel injector circuit

Click here

ECM

Click here

VC output circuit

Click here

Starter signal circuit

Click here

Engine immobiliser system

Click here

No. 1 valve rocker arm sub-assembly* -
Engine cranks normally but has difficulty in starting Fuel pump control circuit

Click here

Engine coolant temperature sensor

Click here

Ignition system

Click here

Compression

Click here

Fuel injector

Click here

Fuel injector circuit

Click here

Air induction system -
Electronic throttle control system

Click here

PCV hose

Click here

Starter signal circuit

Click here

ECM power source circuit

Click here

No. 1 valve rocker arm sub-assembly* -
Difficult to start with cold engine Ignition system

Click here

Spark plug

Click here

Fuel pump control circuit

Click here

Fuel injector

Click here

Starter signal circuit

Click here

Difficult to start with warm engine Fuel injector

Click here

Ignition system

Click here

Spark plug

Click here

Fuel pump control circuit

Click here

Starter signal circuit

Click here

High engine idle speed Electronic throttle control system

Click here

A/C signal circuit

Click here

ECM power source circuit

Click here

Low engine idle speed (Poor idling) Electronic throttle control system

Click here

A/C signal circuit

Click here

Fuel pump control circuit

Click here

Air induction system -
PCV hose

Click here

Rough idling Compression

Click here

Spark plug

Click here

Fuel injector

Click here

Ignition system

Click here

Fuel pump control circuit

Click here

Electronic throttle control system

Click here

Air induction system -
PCV hose

Click here

Mass air flow meter

Click here

No. 1 valve rocker arm sub-assembly* -
Hunting (Poor idling) Electronic throttle control system

Click here

Air induction system -
ECM power source circuit

Click here

Hesitation and/or poor acceleration Fuel pump control circuit

Click here

Spark plug

Click here

Ignition system

Click here

Fuel injector

Click here

Mass air flow meter

Click here

Electronic throttle control system

Click here

Air induction system -
Compression

Click here

Brake override system

Click here

No. 1 valve rocker arm sub-assembly* -
Surging (Poor driveability) Spark plug

Click here

Fuel pump control circuit

Click here

Ignition system

Click here

Fuel injector

Click here

Mass air flow meter

Click here

Variable valve timing system

Click here

Compression

Click here

No. 1 valve rocker arm sub-assembly* -
Engine stalls soon after starting Fuel pump control circuit

Click here

Spark plug

Click here

Ignition system

Click here

Fuel injector

Click here

Variable valve timing system

Click here

Electronic throttle control system

Click here

Air induction system -
PCV hose

Click here

Compression

Click here

No. 1 valve rocker arm sub-assembly* -
Engine stalls only during A/C operation A/C signal circuit

Click here

ECM

Click here

Tech Tips

*: Check the "Fuel Cut Elps Time" in the Data List.

If the elapsed time is over 0 sec, then the engine speed is high (More than the engine speed at which fuel cut occurs + 500 rpm).

When this has happened, there is the possibility that the valve rocker arm will become loose and malfunction, so check that the No. 1 valve rocker arm sub-assembly is properly attached Click here.