REAR CONTROL SWITCH(for Power Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear power seat switch removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	LKA/LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic View Monitor System	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here

*: When performing learning using the GTS.
Click here Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
1. Disconnect the cable from the negative (-) battery terminal.
  
  Click here
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  
  If the airbag deploys for any reason, it may cause a serious accident.
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
  
  Click here
REMOVE REAR CENTER NO. 2 SEAT ARMREST PANEL SUB-ASSEMBLY
1. Remove in this Direction
  
  Detach the clip and claw.
2. While moving the rear center No. 2 seat armrest panel sub-assembly in the direction indicated by the arrow shown in the illustration, detach the guide to remove it.
REMOVE REAR CENTER NO. 2 SEAT ARMREST PANEL
1. Remove in this Direction
  
  Detach the clip and claw.
2. While moving the rear center No. 2 seat armrest panel in the direction indicated by the arrow shown in the illustration, detach the guide to remove it.
REMOVE REAR POWER SEAT SWITCH WITH BRACKET
1. Remove the 4 screws and disconnect the rear power seat switch with bracket from the rear center seat armrest assembly.
REMOVE REAR CENTER SEAT ARMREST BRACKET LH
1. Remove the 2 screws and rear center seat armrest bracket LH.
REMOVE REAR CENTER SEAT ARMREST BRACKET RH
1. Remove the 2 screws and rear center seat armrest bracket RH.
REMOVE REAR CENTER SEAT ARMREST COVER
1. Remove the rear center seat armrest cover.
REMOVE REAR POWER SEAT SWITCH
1. Disconnect the connector.
2. Detach the clamp and remove the rear power seat switch.