ACTIVE NOISE CONTROL MICROPHONE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the active noise control microphone removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	LKA/LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Forward recognition camera Windshield glass (Including removal and installation)	Adjust forward recognition camera	Dynamic radar cruise control system Forward recognition camera system LKA/LDA system Road sign assist system Pre-collision system Automatic high beam system Adaptive high beam system	Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE

PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click here
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  
  Click here
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE ACTIVE NOISE CONTROL MICROPHONE (SPOT LIGHT ASSEMBLY) (for Rear Side)

Click here
REMOVE ROOF HEADLINING ASSEMBLY

Click here
REMOVE ACTIVE NOISE CONTROL MICROPHONE (for Front Side)
1. for 12 Speakers:
  1. Disconnect the connector.
  2. Detach the claws and remove the active noise control microphone.
    
    *A for RH Side *B for LH Side
2. for 24 Speakers:
  1. Disconnect the connector.
  2. Detach the claws and remove the active noise control microphone.
    
    *A for RH Side *B for LH Side