STEERING ANGLE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during steering sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

for 8GR-FKS: Click here

for V35A-FTS: Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

Steering sensor (Including removal and installation) Steering angle neutral point Parking support brake system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Steering angle setting Parking assist monitor system

Click here

Panoramic view monitor system

Click here

*: When performing learning using the GTS.
Click here Click here

CAUTION / NOTICE / HINT

Note

If both the spiral cable sub-assembly and the steering sensor are malfunctioning, replace them with a new spiral with sensor cable sub-assembly.

PROCEDURE


  1. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Click here

  2. REMOVE STEERING SENSOR


    1. B006D89

      Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.

      Note

      Do not damage the claws and pins of the spiral cable sub-assembly.