STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

for 8GR-FKS: Click here

for V35A-FTS: Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

Parts between the steering wheel and tires have been removed/installed, replaced or adjusted Perform actuator angle neutral point calibration and initialization

  • Variable gear ratio steering system

  • Steering wheel off-center

  • DTCs are output

Click here

*: When performing learning using the GTS.
Click here Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. REMOVE HORN BUTTON ASSEMBLY

    Click here

  4. REMOVE STEERING WHEEL ASSEMBLY


    1. Disconnect each connector from the spiral cable with sensor sub-assembly.

    2. B006F9M

      Disconnect the connector from the steering wheel heater control assembly.

    3. B006CZQC01
      *a Matchmark

      Using a 10 mm hexagon socket wrench, remove the steering wheel assembly set bolt.

    4. Put matchmarks on the steering wheel assembly and steering main shaft.

    5. B006ATOC01
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-40011   ( 09957-04010 )
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )
      09950-60011   ( 09951-00220 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  5. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  6. REMOVE NO. 1 STEERING WHEEL ORNAMENT


    1. B006FYE

      Remove the 2 screws.

    2. Disengage the guide pin to remove the No. 1 steering wheel ornament.

  7. REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY

    Click here