TIRE PRESSURE WARNING ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front tire pressure antenna removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly Front television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration
Front bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Intelligent clearance sonar system

  • LEXUS parking assist-sensor system

Click here

Headlight ECU sub-assembly LH

  • Synchronize vehicle information

  • Initialize headlight ECU sub-assembly LH

  • Adaptive high beam system

  • Automatic headlight beam level control system

Click here

PROCEDURE


  1. REMOVE HEADLIGHT ASSEMBLY LH

    for Triple Beam Headlight: Click here

    for Single Beam Headlight: Click here

  2. REMOVE FRONT TIRE PRESSURE ANTENNA


    1. B00800T

      Disengage the guide and remove the bolt.

    2. Disconnect the connector to remove the front tire pressure antenna.