AIRBAG SYSTEM, Diagnostic DTC:B1635/24

DTC Code DTC Name
B1635/24 Rear Airbag Sensor LH Circuit Malfunction

DESCRIPTION

The side collision sensor LH circuit (bus 1) consists of the airbag sensor assembly, door side airbag sensor LH and rear airbag sensor LH.

The door side airbag sensor LH and rear airbag sensor LH detect impacts to the vehicle and send signals to the airbag sensor assembly to determine if the airbags and pretensioners should be deployed.

DTC B1635/24 is stored when a malfunction is detected in the rear airbag sensor LH.

DTC No. Detection Item DTC Detection Condition Trouble Area Test Mode / Check Mode
B1635/24 Rear Airbag Sensor LH Circuit Malfunction

  • Rear airbag sensor LH malfunction

  • Airbag sensor assembly malfunction

  • Rear airbag sensor LH

  • Airbag sensor assembly

 Does not apply to test/check mode

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here

PROCEDURE


  1. CHECK REAR AIRBAG SENSOR LH


    1. B007XZQC01
      *1 Rear Airbag Sensor RH
      *2 Airbag Sensor Assembly

      Turn the engine switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Interchange the rear airbag sensor LH with RH and connect the connectors.

    4. Connect the cable to the negative (-) battery terminal.

    5. Clear the DTCs stored in memory.

      Click here


      Body Electrical > SRS Airbag > Clear DTCs

    6. Turn the engine switch off.

    7. Turn the engine switch on (IG), and wait for at least 60 seconds.

    8. Check for DTCs.

      Click here


      Body Electrical > SRS Airbag > Trouble Codes

      Tech Tips

      Codes other than DTCs B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

      Result
      Result Proceed to
      DTC B1635/24 is output. A
      DTC B1630/23 is output. B
      DTCs B1630/23 and B1635/24 are not output. C

    9. Turn the engine switch off.

    10. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    11. Return the rear airbag sensor LH and RH to their original positions and connect the connectors.


    A

    REPLACE AIRBAG SENSOR ASSEMBLY Click here

    B

    REPLACE REAR AIRBAG SENSOR LH w/o Rear No. 2 Seat: Click here
    REPLACE REAR AIRBAG SENSOR LH w/ Rear No. 2 Seat: Click here

    C

    USE SIMULATION METHOD TO CHECK Click here