DIGITAL AUDIO BROADCASTING ANTENNA INSTALLATION

PROCEDURE

1. INSTALL DIGITAL AUDIO BROADCASTING ANTENNA ASSEMBLY

   
   

   1. Insert the guide into the roof panel hole.

      Note

      Do not touch the contact terminal of the digital audio broadcasting antenna assembly.

      Tech Tips

      There is a protective cover on the new digital audio broadcasting antenna assembly. Remove this cover before replacing parts.

   2. Install the digital audio broadcasting antenna assembly with the nut.

      Torque:

      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

   3. Connect the 2 connectors.

      

      *A	for LH Side	*B	for RH Side
      	Nut		Connector

2. INSTALL ROOF HEADLINING ASSEMBLY

   Click here

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Click here

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

   Click here

5. INSPECT SRS WARNING LIGHT

   Click here

6. INSPECT FRONT SEAT ASSEMBLY

   Click here

7. INSPECT REAR SEAT ASSEMBLY (for Power Seat)

   Click here

8. INSPECT SEAT HEATER SYSTEM (w/ Seat Heater System)

   Click here

9. INSPECT CLIMATE CONTROL SEAT SYSTEM (w/ Climate Control Seat System)

   Click here

10. INSPECT SEAT VIBRATION SYSTEM (w/ Refresh Seat)

    Click here

11. INSPECT SEAT BELT WARNING SYSTEM

    Click here