AIRBAG SYSTEM Diagnosis Circuit

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.

DTCs are output by the blinking of the SRS warning light.

Tech Tips


  • When each warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.

  • A DTC output mode signal is transmitted through the CAN communication system to each ECU including the center airbag sensor. Thus, when all systems do not enter DTC output mode, there may be an ECM malfunction.

WIRING DIAGRAM

A01IP41E04

INSPECTION PROCEDURE

Note


  • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  • When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if a CAN communication system DTC is output.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    REPAIR TROUBLE AREAS INDICATED BY OUTPUT DTCS Click here

    A

  2. CHECK HARNESS AND CONNECTOR (DLC3 - ECM)


    1. A01IMYNE04
      Text in Illustration
      *1 Front view of DLC3
      *2

      Front view of wire harness connector

      (to ECM)
      *3 for ZR Series Engine
      *4 for AD Series Engine

      Turn the ignition switch off.

    2. Disconnect the A51 connector from the ECM.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for ZR Series Engine
      Tester Connection Condition Specified Condition
      H16-13 (TC) - A51-41 (TC) Always Below 1 Ω
      for AD Series Engine
      Tester Connection Condition Specified Condition
      H16-13 (TC) - A51-26 (TC) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    1. A01IQPSE04
      Text in Illustration
      *1 Front view of DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H16-4 (CG) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (TC OF ECM - BODY GROUND)


    1. A01IP34E04
      Text in Illustration
      *1

      Front view of wire harness connector

      (to ECM)
      *2 for ZR Series Engine
      *3 for AD Series Engine

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for ZR Series Engine
      Tester Connection Condition Specified Condition
      A51-41 (TC) - Body ground Always 1 MΩ or higher
      for AD Series Engine
      Tester Connection Condition Specified Condition
      A51-26 (TC) - Body ground*2 Always 1 MΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE CENTER AIRBAG SENSOR ASSEMBLY Click here