Click here

GENERATOR (for 130 A Type) INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL GENERATOR ASSEMBLY


    1. A01ISLO

      Install the generator assembly with the 3 bolts.

      25 N*m 255 kgf*cm 18 ft.*lbf
      Note:

      Make sure that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and generator when installing the generator assembly.

    2. Attach the wire clamp.

    3. A01IN5D

      Connect the generator wire with the nut and bolt.

      for nut
      9.8 N*m 100 kgf*cm 87 in.*lbf
      for bolt
      8.4 N*m 85 kgf*cm 74 in.*lbf

    4. Connect the generator connector and attach the clamp.

    5. Install the terminal cap.

  2. Click here

    INSTALL FAN AND GENERATOR V BELT


    1. A01ISZME02

      Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the fan and generator V belt.

      09216-42010
      CAUTION:

      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the fan and generator V belt, pulleys, etc.

      Note:

      • Make sure that the fan and generator V belt is set properly on each pulley.

      • Make sure SST is installed as shown in the illustration. If not, SST and/or the fan and generator V belt may not be able to be removed.

      Table 1. Text in Illustration
      *A w/o Air Conditioning System *B w/ Air Conditioning System
  3. Click here

    INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A01INC5E01

      Install the front suspension member reinforcement RH with the 4 bolts.

      99 N*m 1010 kgf*cm 73 ft.*lbf
      Note:

      Tighten the bolts in the order shown in the illustration.

  4. Click here

    INSTALL REAR ENGINE UNDER COVER RH


    1. Install the under cover with the 5 clips.

  5. Click here

    INSTALL NO. 1 ENGINE UNDER COVER


    1. Install the No. 1 engine under cover with the 10 clips and 6 bolts.

  6. Click here

    INSTALL RADIATOR SUPPORT OPENING COVER


    1. Attach the 4 hooks to install the radiator support opening cover.

    2. Install the 3 clips.

  7. Click here

    INSTALL NO. 1 ENGINE COVER


    1. A01INMI

      Attach the 4 clips to install the No. 1 engine cover.

  8. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  9. Click here

    INSTALL FRONT DRIVE SHAFT ASSEMBLY RH


    1. Install the front drive shaft assembly RH (Click here).