NAVIGATION ANTENNA REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY


    1. Remove the instrument panel safety pad Click here.

  4. REMOVE INSTRUMENT PANEL STAY LH (for LHD)

    A01IT8E

    1. Remove the 2 screws <B> and instrument panel stay.

  5. REMOVE NAVIGATION ANTENNA ASSEMBLY (for LHD)


    1. A01ITCB

      Remove the 2 screws and heater to register duct assembly.

    2. A01ITS2

      Detach the 3 clamps.

    3. Remove the 2 screws and navigation antenna.

  6. REMOVE NAVIGATION ANTENNA CORD SUB-ASSEMBLY (for LHD)


    1. A01IUJW

      Detach the 2 clamps and remove the navigation antenna cord.

  7. REMOVE INSTRUMENT PANEL STAY RH (for RHD)

    Tech Tips

    Use the same procedure described for the LH side.

  8. REMOVE NAVIGATION ANTENNA ASSEMBLY (for RHD)


    1. A01IRAD

      Remove the 2 screws and heater to register duct assembly.

    2. A01IRJ9

      Detach the 3 clamps.

    3. Remove the 2 screws and navigation antenna.

  9. REMOVE NAVIGATION ANTENNA CORD SUB-ASSEMBLY (for RHD)


    1. A01IQC7

      Detach the 2 clamps and remove the navigation antenna cord.