Click here

FRONT DOOR SPEAKER INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

    Note:

    Do not touch the cone part of the speaker.


    1. A01IUIE

      Temporarily install the speaker by attaching the claw of the speaker to the door panel.

    2. Using an air riveter or hand riveter, install the speaker with 3 new rivets.

      Note:
      • A01ISHTE12

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

        Table 1. Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Mandrel
        *4 Riveter
      • A01IUM1E11

        Confirm that the rivets are seated properly against the speaker.

        Table 2. Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Riveter

      • Do not tilt the riveter when installing the rivet to the speaker.

      • Do not leave any space between the rivet head and speaker.

      • A01IQGIE11

        Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

        Table 3. Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Riveter

    3. Connect the connector.

  2. Click here

    INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH


    1. A01IOHC

      Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly to install the inside handle.

  3. Click here

    INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01IUHM

      Attach the 2 claws to install the front door inside handle sub-assembly to the door trim board.

    2. A01IS0O

      Attach the front door trim board with the 5 claws of the front door inner glass weatherstrip and the reference boss.

    3. w/ Courtesy Light:


      1. Connect the courtesy light connector.

    4. A01IR1B

      Attach the 9 clips to install the trim board.

    5. Install the 3 screws.

  4. Click here

    INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Tip:

    Use the same procedure described for the driver side.

  5. Click here

    INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


    1. Connect the connector.

    2. Attach the 7 claws and clip to install the power window regulator master switch assembly with front door armrest base panel.

  6. Click here

    INSTALL FRONT DOOR TRIM MOULDING LH


    1. A01IPP4

      Attach the 8 claws to install the front door trim moulding.

  7. Click here

    INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH


    1. A01IRBS

      Attach the 3 claws to install the inside handle bezel.

  8. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).