REAR DOOR SPEAKER INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL REAR SPEAKER ASSEMBLY

    Note

    Do not touch the cone part of the speaker.


    1. Temporarily install the speaker by attaching the claw of the speaker to the door panel.

    2. A01IS1W

      Using an air riveter or hand riveter, install the speaker with 3 new rivets.

      Note


      • A01ISHTE12

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

        Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Mandrel
        *4 Riveter
      • A01IUM1E11

        Confirm that the rivets are seated properly against the speaker.

        Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Riveter

      • Do not tilt the riveter when installing the rivet to the speaker.

      • Do not leave any space between the rivet head and speaker.

      • A01IQGIE11

        Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

        Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Riveter

    3. Connect the connector.

  2. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH


    1. A01ISMJ

      Connect the 2 cables to the inside handle to install the inside handle.

  3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01IODC

      Install the clamp to the door panel.

    2. A01IO4S

      Attach the 2 claws to install the inside handle to the rear door trim board.

    3. A01IQESE01
      Text in Illustration
      *1 w/ Rear Door Sunshade
      *2 w/o Rear Door Sunshade

      Attach the rear door trim board with the 4 claws on the rear door inner glass weatherstrip.

    4. A01IP0B

      Install the rear door trim board with the 10 clips.

    5. Install the 3 screws.

  4. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)


    1. Connect the connector.

    2. A01IREP

      Attach the 4 claws to install the rear power window regulator switch assembly with rear door armrest base panel.

  5. INSTALL REAR DOOR TRIM MOULDING LH


    1. A01IR9Q

      Attach the 8 claws to install the door trim moulding.

  6. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH


    1. A01IT23

      Attach the 3 claws to install the rear door inside handle bezel.

  7. INSTALL REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)


    1. Install the rear door regulator inside handle plate.

  8. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    1. Temporarily install the rear door window regulator handle assembly, fully close the window, and then remove the rear door window regulator handle assembly.

    2. Install the snap ring to the rear door window regulator handle assembly.

    3. A01IR9XE01
      Text in Illustration
      *1 Front Side

      Install the rear door window regulator handle assembly as shown in the illustration.

      Standard
      Area Specified Condition
      A 50° to 60°

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.