REVOLUTION SENSOR REMOVAL


  1. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IQMS

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System for HDD:

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE BATTERY


    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  4. REMOVE BATTERY CARRIER


    1. A01INC1

      Disconnect the 2 wire harness clamps from the battery carrier.

    2. Remove the 2 bolts and disconnect the radiator pipe from the battery carrier.

    3. A01IN2I

      Remove the 4 bolts and battery carrier.

  5. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01ISXU

      Remove the 11 clips, 6 bolts and under cover.

  6. REMOVE REAR ENGINE UNDER COVER LH


    1. Remove the 5 clips and under cover.

  7. REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

    A01IUEY

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.

  8. REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)

    A01IRHA

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.

  9. REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)

    A01IN6Z

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.