Click here

SHIFT PADDLE SWITCH INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. Install the 2 shift switches and 2 brackets with the 4 screws.

      2.4 N*m 24 kgf*cm 21 in.*lbf
      Note:

      Make sure that the brackets are securely installed.

    2. A01ITAKE01

      Connect the 3 switch wire connectors to the 2 shift switches and steering pad switch harness connector.

    3. Attach the wire harness to the 2 guides.

  2. Click here

    PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  3. Click here

    ADJUST SPIRAL CABLE


    1. Turn the ignition switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01IUFO

      Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

    4. A01ITLH

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      CAUTION:

      Do not turn the spiral cable by the airbag wire harness.

      Tip:

      The spiral cable can be rotated approximately 2.5 turns to both the left and right from the center.

  4. Click here

    INSTALL STEERING WHEEL ASSEMBLY


    1. A01IQZBE01

      Align the matchmarks on the steering wheel assembly and steering main shaft.

      Table 1. Text in Illustration
      *1 Matchmark

    2. Install the steering wheel assembly set nut.

      50 N*m 510 kgf*cm 37 ft.*lbf

    3. Connect the connectors to the spiral cable sub-assembly.

  5. Click here

    INSTALL STEERING PAD


    1. A01INT0

      Support the steering pad with one hand.

    2. Connect the connector to the steering pad.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. Connect the horn connector.

    4. Attach the 2 springs to install the steering pad.

  6. Click here

    INSPECT STEERING WHEEL CENTER POINT

  7. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  8. Click here

    INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light (Click here).