CRUISE CONTROL SYSTEM (except 1WW) Cruise Main Indicator Light Circuit

DESCRIPTION

• When the ECM detects a cruise control switch on signal from the cruise control switch, the ECM sends the signal to the combination meter through CAN communication. Then the CRUISE main indicator light turns on.

• The CRUISE main indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (CRUISE MAIN INDICATOR LIGHT)

   
   

   1. Select the item below in the Active Test, and then check that the CRUISE main indicator light illuminates.

      Combination Meter

      Tester Display	Test Part	Control Range	Diagnostic Note
      Indicat. Lamp Cruise	CRUISE main indicator light	ON/OFF	-

      OK
      Indicator light turns on/off.

   
   

   NG

   GO TO METER / GAUGE SYSTEM Click here

   OK

2. READ VALUE USING INTELLIGENT TESTER (CRUISE MAIN INDICATOR LIGHT)

   
   

   1. Use the Data List to check if the CRUISE main indicator light is functioning properly.

      Cruise Control

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      CCS Indicator M-CPU	CRUISE main indicator (Main CPU) / ON or OFF	ON: CRUISE main indicator light on OFF: CRUISE main indicator light off	-

      OK
      On screen, item changes between ON and OFF according to above chart.

      Result

      Result	Proceed to
      OK	A
      NG (for 1ZR-FAE)	B
      NG (for 2ZR-FAE)	C

   
   

   B

   REPLACE ECM Click here

   C

   REPLACE ECM Click here

   A

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here