REMOVE RADIATOR SUPPORT OPENING COVER
Remove the 3 clips.
Detach the 4 hooks and remove the radiator support opening cover.
PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
REMOVE NO. 2 CYLINDER HEAD COVER
Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.
Attempting to detach both front and rear clips at the same time may cause the cover to break.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Disconnect the mass air flow meter connector.
Detach the 2 clamps and disconnect the wire harness.
Disconnect the 2 clamps.
Disconnect the PCV hose.
Loosen the band and remove the air cleaner cap.
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Detach the wire harness clamp from the air cleaner case.
Remove the 3 bolts and air cleaner case.
REMOVE NO. 1 AIR CLEANER INLET
Remove the clip.
Detach the 2 claws and remove the No. 1 air cleaner inlet.
DISCONNECT NO. 2 AIR CLEANER INLET
Remove the bolt and disconnect the No. 2 air cleaner inlet from the vehicle body.
REMOVE ECM
Detach the wire harness clamp.
Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.
Remove the 2 bolts and ECM.
Remove the 2 screws and No. 1 ECM bracket.
Remove the 2 screws and No. 2 ECM bracket.