Click here

WATER PUMP REMOVAL

Click here
Click here Click here
  1. Click here

    REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IQMS

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  2. Click here

    REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note:

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  3. Click here

    REMOVE NO. 1 ENGINE UNDER COVER


    1. A01ISXU

      Remove the 11 clips, 6 bolts and under cover.

  4. Click here

    REMOVE REAR ENGINE UNDER COVER RH


    1. A01IP88

      Remove the 5 clips and under cover RH.

  5. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  6. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  7. Click here

    DRAIN ENGINE COOLANT


    1. Loosen the radiator drain cock plug.

      Tip:

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. A01INZOE01

      Remove the radiator reservoir cap.

      CAUTION:

      Do not remove the radiator reservoir cap while the engine and radiator are still hot.

      Pressurized, hot engine coolant and steam may be released and cause serious burns.

      Table 1. Text in Illustration
      *1 Radiator Reservoir Cap *2 Radiator Drain Cock Plug
  8. Click here

    REMOVE V-RIBBED BELT


    1. A01ITH6E01

      Loosen bolts A and B.

    2. Loosen bolt C and remove the V-ribbed belt.

      Note:

      Do not loosen bolt D.

  9. Click here

    REMOVE GENERATOR ASSEMBLY


    1. A01IUOO

      Remove the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the connector and detach the wire harness clamp.

    4. A01IO51E01

      Remove the 2 bolts and adjusting bar.

    5. A01IO9BE01

      Remove the bolt and generator.

    6. A01IU2G

      Remove the bolt and wire harness clamp bracket.

  10. Click here

    REMOVE WATER PUMP ASSEMBLY


    1. A01IOJW

      Remove the 5 bolts and water pump from the timing chain cover.

    2. A01IPUJE01

      Remove the gasket from the timing chain cover.