ДАТЧИК УРОВНЯ МАСЛА УСТАНОВКА


  1. INSTALL ENGINE OIL LEVEL SENSOR


    1. Clean the engine oil level sensor installation area in the oil pan sub-assembly.

    2. Install a new gasket to the engine oil level sensor.

    3. Install the engine oil level sensor with the 4 bolts.

      Torque:
      8.2 N*m  { 84 kgf*cm, 73 in.*lbf }

    4. Connect the engine oil level sensor connector.

  2. ADD ENGINE OIL


    1. Add new engine oil and install the oil filler cap.

      Standard Oil Grade
      Oil Grade Viscosity (SAE)
      API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil

      • 0W-20

      • 5W-20

      • 5W-30

      • 10W-30
      API grade SL, SM or SN multigrade engine oil

      • 15W-40

      • 20W-50
      Standard Capacity
      Item Specified Condition
      Drain and refill without oil filter change 4.1 liters (4.3 US qts, 3.6 Imp. qts)
      Drain and refill with oil filter change 4.5 liters (4.8 US qts, 4.0 Imp. qts)
      Dry fill 5.9 liters (6.2 US qts, 5.2 Imp. qts)

  3. INSPECT ENGINE OIL LEVEL


    1. Put the engine in inspection mode (maintenance mode) Click here.

    2. Warm up the engine, stop it and wait 5 minutes. The engine oil level should be between the low level mark and full level mark on the engine oil level dipstick.

      If the engine oil level is low, check for leaks and add engine oil to the full level mark.

      Note

      Do not add engine oil to above the full level mark.

      Tech Tips

      A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.


      • When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.

      • If low quality oil or oil of an inappropriate viscosity is used.

      • When driving at high engine speeds or with a heavy load (when towing, etc.), or when accelerating or decelerating frequently while driving.

      • When leaving the vehicle idling for a long time, or when driving frequently in heavy traffic.

      When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.

  4. INSPECT FOR OIL LEAK


    1. Put the engine in inspection mode (maintenance mode) Click here

    2. Start the engine. Make sure that there are no oil leaks from the area that was worked on.

  5. INSTALL NO. 2 ENGINE UNDER COVER


    1. Установите защиту картера двигателя № 2 и закрепите ее 4 винтами и 2 уплотнительными шайбами.

  6. INSTALL FRONT SUSPENSION MEMBER BRACE


    1. Установите скобу элемента передней подвески и закрепите ее фиксатором и 4 болтами.

      Torque:
      52 Н*м  { 53 кгс*см, 38 фунт-сила-футов }