ЭЛЕКТРОННЫЙ БЛОК ПРИВОДА ФОРСУНОК СНЯТИЕ


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE AIR CLEANER HOSE ASSEMBLY

    Click here

  4. REMOVE COOL AIR INTAKE DUCT SEAL (for LHD)


    1. A01FS00

      Снимите 7 фиксаторов и сальник впускного воздухопровода холодного воздуха.

  5. REMOVE INLET NO. 1 AIR CLEANER (for LHD)


    1. A01FUV7

      Выверните болт и снимите входной патрубок воздушного фильтра № 1.

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (for LHD)


    1. Снимите фильтрующий элемент воздушного фильтра в сборе на корпус воздушного фильтра.

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for LHD)


    1. A01FU00E01
      Обозначения на рисунке
      *a Опора воздушного фильтра

      Отсоедините зажим жгута проводов от корпуса воздушного фильтра в сборе.

    2. Выверните 2 болта и снимите корпус воздушного фильтра в сборе.

      Note

      Убедитесь, что опора воздушного фильтра присоединена к кузову.

  8. DISCONNECT INVERTER RESERVE TANK ASSEMBLY (for LHD)


    1. A01FV98

      Detach the clamp to disconnect the wire harness from the inverter reserve tank assembly.

    2. Detach the clamp to disconnect the inlet hybrid water pump hose from the No. 1 inverter reserve tank bracket.

    3. Detach the clamp to disconnect the No. 3 inverter cooling hose from the No. 1 inverter reserve tank bracket.

    4. Remove the 2 bolts and disconnect the inverter reserve tank assembly from the No. 1 inverter reserve tank bracket.

  9. REMOVE NO. 1 INVERTER RESERVE TANK BRACKET (for LHD)


    1. A01FRTI

      Выверните болт и отсоедините жгут электропроводки двигателя № 3 от кронштейна расширительного бачка инвертора № 1.

    2. Открепите 2 зажима жгута проводов от кронштейна расширительного бачка инвертора № 1.

    3. A01FQXM

      Выверните 2 болта и снимите кронштейн расширительного бачка инвертора № 1.

  10. REMOVE INJECTOR DRIVER


    1. A01FQQWE01
      Text in Illustration
      *a Lock Lever
      *b Lock
      *c Connector (with Lock)

      Push the lock and move each lock lever in the direction indicated by the arrow to disconnect the connector (with lock) from the injector driver.

    2. Disconnect the 2 injector driver connectors.

    3. Remove the 2 bolts, 2 nuts and injector driver from the intake manifold.

      Note

      Be careful not to drop or strike the injector driver.