VEHICLE STABILITY CONTROL SYSTEM Slip Indicator Light Remains ON

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

The slip indicator light blinks during VSC and/or TRC operation.

If a malfunction is detected, the slip indicator light comes on to warn the driver Click here.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

   
   

   1. Check if a CAN communication system DTC is output Click here.

      Result
      Result Proceed to DTC is not output. A DTC is output. B

   
   

   B

   INSPECT CAN COMMUNICATION SYSTEM Click here

   A

2. CHECK IF BRAKE ACTUATOR ASSEMBLY CONNECTOR IS SECURELY CONNECTED

   
   

   1. Check if the skid control ECU (brake actuator assembly) connector is securely connected.

      OK
      The connector is securely connected.

   
   

   NG

   CONNECT CONNECTOR TO ECU CORRECTLY

   OK

3. CHECK BATTERY

   
   

   1. Check the battery voltage.

      Standard Voltage
      11 to 14 V

   
   

   NG

   CHECK OR REPLACE CHARGING SYSTEM COMPONENT OR BATTERY Click here

   OK

4. INSPECT COMBINATION METER ASSEMBLY

   
   

   1. Perform an Active Test of the combination meter assembly (meter CPU) using the GTS Click here.

   2. Check the combination meter assembly.

      OK
      The slip indicator light turns on or off in accordance with the Active Test operation.

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts Click here.

   
   

   OK

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here

   NG

   REPLACE COMBINATION METER ASSEMBLY Click here