BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:U1331

DTC Code DTC Name
U1331 Software Incompatibility with Body Control Module "B"

DESCRIPTION

This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.

DTC Code DTC Detection Condition Trouble Area
U1331 Destination information of the main body ECU (multiplex network body ECU) and blind spot monitor sensor do not match.

  • Main body ECU (multiplex network body ECU)

  • Blind spot monitor sensor RH

  • Blind spot monitor sensor LH

INSPECTION PROCEDURE

Note


  • When checking for DTCs, make sure that the blind spot monitor main switch (integration control and panel assembly) is on.

  • If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.

PROCEDURE


  1. CONFIRM PART NUMBER (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU])


    1. Check the main body ECU (multiplex network body ECU) part number.


      1. Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.

        OK
        The parts number is correct.

    NG

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

    OK

  2. CHECK DTC (CAN COMMUNICATION SYSTEM)


    1. Clear the DTCs.


    2. Recheck for DTCs and check if the same DTC is output again.

      Result
      Result Proceed to
      No DTC is output A
      DTC is output from the blind spot monitor sensor RH B
      DTC is output from the blind spot monitor sensor LH C

    B

    REPLACE BLIND SPOT MONITOR SENSOR RH Click here

    C

    REPLACE BLIND SPOT MONITOR SENSOR LH Click here

    A

    USE SIMULATION METHOD TO CHECK Click here