REAR DOOR SPEAKER REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


    1. Remove the luggage compartment floor mat.

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH


    1. Remove the luggage compartment trim cover LH.

  4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A01FT6P

      Detach the 3 claws and remove the rear door inside handle bezel plug.

  6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. A01FVID

      Detach the 2 clips and 5 claws.

    2. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.

  7. REMOVE REAR DOOR HOLE COVER


    1. Remove the rear door hole cover.

  8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01FTBQ

      Remove the 3 screws.

    2. Detach the 8 clips.

    3. A01FVC3E01

      Detach the reference boss in the direction indicated by the arrow in the illustration.

    4. Using a screwdriver, detach the 3 claws and remove the rear door trim board.

      Tech Tips

      Tape the screwdriver tip before use.

      Text in Illustration
      *1 Reference Boss
      *2 Protective Tape

    5. Disconnect each connector.

    6. A01FROJ

      Disconnect the rear door lock remote control cable and rear door inside locking cable.

  9. REMOVE REAR SPEAKER ASSEMBLY


    1. A01FQFAE01
      Text in Illustration
      *A w/o Mark Levinson Speaker System
      *B w/ Mark Levinson Speaker System

      Disconnect the connector.

    2. Remove the 4 screws.

    3. Detach the claw and remove the rear speaker assembly.

      Note

      Do not touch the cone of the speaker.

  10. REMOVE REAR NO. 2 SPEAKER ASSEMBLY


    1. A01FRO1

      Disconnect the connector.

    2. Remove the screw.

    3. Detach the clamp and remove the rear No. 2 speaker assembly.

      Note

      Do not touch the cone of the speaker.