STEERING ACTUATOR REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE STEERING COLUMN ASSEMBLY

    Click here

  2. REMOVE STEERING SLIDING WITH SHAFT YOKE SUB-ASSEMBLY


    1. A01FT74E01
      Text in Illustration
      *a Matchmark

      Loosen the bolt labeled A and remove the bolt labeled B, and then slide the steering sliding with shaft yoke sub-assembly.

      Note


      • Do not remove the bolt labeled A.

      • Do not disconnect the steering sliding with shaft yoke sub-assembly from the power steering link assembly.

    2. Put matchmark on the steering sliding with shaft yoke sub-assembly and steering actuator assembly.

    3. A01FVLHE02
      Text in Illustration
      *a Matchmark

      Put matchmarks on the steering sliding with shaft yoke sub-assembly and power steering link assembly.

    4. Disconnect the steering sliding with shaft yoke sub-assembly from the power steering link assembly.

    5. Remove the bolt and steering sliding with shaft yoke sub-assembly from the steering actuator assembly.

  3. REMOVE MAIN SHAFT LOWER DUST COVER


    1. A01FT1Y

      Remove the 2 bolts and dust cover.

  4. REMOVE STEERING ACTUATOR ASSEMBLY


    1. A01FPXLE03

      While pushing the claws on both sides of the connector, move the lock in the direction of the arrow.

    2. Disconnect the connector from the steering actuator assembly.

    3. Remove the wire harness clamp from the steering column hole cover.

    4. A01FSPW

      Pinch the clamp using needle-nose pliers, and then insert a precision screwdriver, turn it in the direction shown in the illustration and remove the No. 1 steering column hole cover clamp.

    5. A01FTS6E06
      Text in Illustration
      *a Matchmark

      Put matchmarks on the steering actuator assembly and steering column hole shield.

    6. Remove the steering actuator assembly.