REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

      Note

      Keep the lip free of foreign matter.

    2. A01FR6SE01
      Text in Illustration
      *1 Depth

      Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Standard depth
      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note


      • Wipe off any excess grease on the crankshaft.

      • Keep the lip free of foreign matter.

      • Do not tap on the oil seal at an angle.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY


    1. A01FVWQE01

      Using SST, hold the crankshaft pulley.

      SST
      09213-70010   ( 09213-70020 )
      09330-00021

    2. Clean the 8 bolts and 8 bolt holes.

    3. Apply a few drops of adhesive to 2 or 3 threads of the 6 bolt tips.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    4. A01FR3TE01

      In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      83 N*m  { 846 kgf*cm, 61 ft.*lbf }

  3. INSTALL TRANSMISSION INPUT DAMPER COVER ASSEMBLY


    1. A01FUFI

      Install the damper cover with the 9 bolts.

      Torque:
      49 N*m  { 504 kgf*cm, 36 ft.*lbf }
      Text in Illustration
      A01FRJI Flywheel Side

      Note

      Make sure to insert the damper cover in the correct direction.

  4. INSTALL HYBRID VEHICLE TRANSMISSION ASSEMBLY

    Click here

  5. INSPECT FOR OIL LEAK


    1. Put the engine in inspection mode Click here.

    2. Start the engine. Make sure that no oil leaks from the connection point of the oil filter cap.