BATTERY COOLING DUCT (w/ Filter) REMOVAL


  1. PRECAUTION (w/ Rear Seat Side Airbag)

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT (w/ Rear Seat Side Airbag)


    1. Remove the luggage compartment floor mat.

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH (w/ Rear Seat Side Airbag)


    1. Remove the luggage compartment trim cover LH.

  4. DISCONNECT CABLE FROM AUXILIARY NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag)

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE REAR SEAT ASSEMBLY

    Click here

  6. REMOVE REAR DOOR SCUFF PLATE LH


    1. Place your hands on the inner portion of the rear door scuff plate LH and detach the 2 claws labeled A, 6 claws labeled B and 2 claws labeled C in the order shown in the illustration.

    2. Raise the rear door scuff plate LH to detach the 4 clips on the outer side and remove it.

      A01FQGSE01
      Text in Illustration
      *1 Claw A *2 Claw B
      *3 Claw C - -

  7. REMOVE REAR SEAT SIDE GARNISH LH

    A01FQIB

    1. Detach the 4 claws and guide and remove the rear seat side garnish LH.

  8. REMOVE NO. 6 HYBRID BATTERY INTAKE DUCT

    Tech Tips

    If the message "Cooling performance of the hybrid battery is low Consult a dealer" is displayed on the multi-information display in the combination meter assembly, inspect the No. 6 hybrid battery intake duct after removing it Click here.


    1. A01FUWS

      Roll up the No. 1 room partition pad.

    2. A01FT0W

      Remove the 2 clips.

    3. Disconnect the No. 6 hybrid battery intake duct from the No. 3 hybrid battery intake duct and remove it.

  9. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side.

  10. REMOVE REAR SEAT SIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  11. REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT

    Tech Tips

    If the message "Cooling performance of the hybrid battery is low Consult a dealer" is displayed on the multi-information display in the combination meter assembly, inspect the No. 1 hybrid battery intake duct after removing it Click here.


    1. A01FS72

      Remove the 2 clips.

    2. Disconnect the No. 1 hybrid battery intake duct from the No. 3 hybrid battery intake duct and remove it.