HEATED OXYGEN SENSOR INSTALLATION

INSTALL HEATED OXYGEN SENSOR

1. 

   Text in Illustration

   *1	Fulcrum Length

   for Bank 2 Sensor 2:

   Using SST, install the heated oxygen sensor.

   SST

   09224-00010

   Torque:

   without SST

   44 N*m  { 449 kgf*cm, 32 ft.*lbf }

   with SST

   40 N*m  { 408 kgf*cm, 30 ft.*lbf }

   Tech Tips

   
   

   • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

   • Make sure SST and the wrench are connected in a straight line.

   • Perform "Inspection After Repairs" after replacing the heated oxygen sensor Click here.

2. 

   Text in Illustration

   *1	Fulcrum Length

   for Bank 1 Sensor 2:

   Using SST, install the heated oxygen sensor.

   SST

   09224-00010

   Torque:

   without SST

   44 N*m  { 449 kgf*cm, 32 ft.*lbf }

   with SST

   40 N*m  { 408 kgf*cm, 30 ft.*lbf }

   Tech Tips

   
   

   • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

   • Make sure SST and the wrench are connected in a straight line.

   • Perform "Inspection After Repairs" after replacing the heated oxygen sensor Click here.

3. Pass the heated oxygen sensor connector through the floor panel and install the grommet.

CONNECT HEATED OXYGEN SENSOR CONNECTOR

1. for Bank 1 Sensor 2:

   Connect the heated oxygen sensor connector.

2. for Bank 2 Sensor 2:

   Connect the heated oxygen sensor connector.

INSTALL INSTRUMENT PANEL FINISH PANEL END RH

Click here