OIL LEVEL SENSOR INSTALLATION


  1. INSTALL ENGINE OIL LEVEL SENSOR


    1. Install a new gasket to the engine oil level sensor.

    2. Install the engine oil level sensor with the 4 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

      Tech Tips

      Be sure to clean the contact surface.

    3. Connect the engine oil level sensor connector.

  2. CONNECT INVERTER COOLING PIPE


    1. Connect the inverter cooling pipe with the 3 bolts.

      Torque:
      22 N*m  { 224 kgf*cm, 16 ft.*lbf }

  3. ADD ENGINE OIL


    1. Add clean engine oil.

      Note

      Do not allow engine oil to adhere to the moving parts of the belt tensioner, as this may cause malfunctions.

      A01FQYU

      If engine oil is on the location indicated by the arrow, replace the belt tensioner.

      Standard Engine Oil
      Oil Grade Oil Viscosity (SAE)
      API grade SL "energy-conserving", SM "energy-conserving", SN "resource-conserving" or ILSAC multigrade engine oil

      • 0W-20

      • 5W-20

      • 5W-30

      • 10W-30
      API grade SL, SM or SN multigrade engine oil

      • 15W-40

      • 20W-50
      Standard Capacity
      Item Specified Condition
      Drain and refill without oil filter change 5.9 liters (6.2 US. qts., 5.2 Imp. qts.)
      Drain and refill with oil filter change 6.3 liters (6.7 US. qts., 5.5 Imp. qts.)
      Dry fill 7.2 liters (7.6 US. qts., 6.3 Imp. qts.)

    2. Install the oil filler cap.

  4. INSPECT FOR OIL LEAK


    1. Put the engine in inspection mode Click here.

    2. Start the engine. Make sure that no oil leaks from the connection point of the oil filter cap.

  5. INSPECT ENGINE OIL LEVEL


    1. Put the engine in inspection mode Click here.

    2. Warm up and stop the engine, and then wait for 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.

      If low, check for leakage and add oil up to the full level mark.

      Note

      Do not add engine oil to above the full level mark.

  6. INSTALL NO. 2 ENGINE UNDER COVER


    1. Install the No. 2 engine under cover with the 4 screws and 2 grommets.

  7. INSTALL FRONT SUSPENSION MEMBER BRACE


    1. Install the front suspension member brace with the clip and 4 bolts.

      Torque:
      52 N*m  { 530 kgf*cm, 38 ft.*lbf }

  8. INSTALL ENGINE UNDER COVER


    1. Install the engine under cover with the 13 screws and 3 clips.