AUTOMATIC LIGHT CONTROL SENSOR REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL


    1. Put protective tape around the upper instrument cluster finish panel.

    2. Remove the 3 clips <B>.

    3. Detach the 2 clips and 3 claws and remove the upper instrument cluster finish panel.

      A01FH7CE01
      Text in Illustration
      *A for 12.3 Inch *B for 8 Inch
      *1 Protective Tape - -

  4. REMOVE MULTI-DISPLAY (for 8 Inch)


    1. A01FDG1

      Remove the 4 screws.

    2. A01FE71

      Move the multi-display in the direction of the arrow in the illustration.

    3. A01FEMU

      Disconnect all the connectors and remove multi-display.

  5. REMOVE ACCESSORY METER ASSEMBLY (for 12.3 Inch)


    1. A01FDMD

      Remove the 4 screws.

    2. A01FIVP

      Move the multi-display in the direction of the arrow in the illustration.

    3. A01FG1I

      Disconnect all the connectors and remove multi-display.

  6. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


    1. A01FI15

      Detach the 2 claws and remove the automatic light control sensor.

    2. Disconnect the connector.