HAZARD WARNING SWITCH REMOVAL


  1. PRECAUTION

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When replacing the multi-media module receiver assembly or DCM (telematics transceiver), perform the vehicle contract setting Click here.

    • The safety connect device uses the DCM (telematics transceiver) to provide access to the network service.

    • The telematics transceiver has a DCM ID (described on the label attached to the DCM (telematics transceiver)).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    A01FD7VE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the center instrument cluster finish panel.

    2. Detach the 9 clips and guide.

    3. Disconnect the connector and remove the center instrument cluster finish panel.

  4. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET


    1. A01FG68

      Remove the 2 screws.

    2. A01FHN5

      Detach the 2 claws and 2 clips.

    3. Pull out the multi-media module receiver assembly with bracket.

    4. Disconnect the connectors and remove the multi-media module receiver assembly with bracket.

  5. REMOVE NO. 1 ION GENERATOR SUB-ASSEMBLY

    A01FF8T

    1. Detach the claw.

    2. Remove the 2 screws and No. 1 ion generator sub-assembly.

    3. A01FDYVE01
      Text in Illustration
      *1 Rear Air Duct Sub-assembly

      Detach the 2 claws and remove the rear air duct sub-assembly.

  6. REMOVE NO. 1 RADIO BRACKET


    1. A01FDDUE01

      Remove the screw labeled A and ion generator bracket.

    2. Remove the 3 screws and No. 1 radio bracket.

  7. REMOVE NO. 2 RADIO BRACKET


    1. A01FHBTE02

      Remove the screw labeled A and ion generator bracket.

    2. Remove the 4 screws and No. 2 radio bracket.