LUGGAGE COMPARTMENT DOOR OPENER MAIN SWITCH REMOVAL

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL
Text in Illustration

*1 Protective Tape
1. Put protective tape around the center instrument cluster finish panel.
2. Detach the 9 clips and guide.
3. Disconnect the connector and remove the center instrument cluster finish panel.
REMOVE INSTRUMENT SIDE PANEL RH
Text in Illustration

*1 Protective Tape
1. Put protective tape around the instrument side panel RH.
2. Using a moulding remover, detach the 7 clips and remove the instrument side panel RH.
3. w/ Airbag Cut Off Switch:
  1. Disconnect the connector.
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
1. Detach the 5 clips and 2 guides.
2. Disconnect the connectors, detach the clamp and remove the No. 2 instrument panel under cover sub-assembly.
REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Text in Illustration

*1 Screw <A>

*2 Bolt <E>
1. Remove the 3 screws <A> and 2 bolts <E>.
2. Detach the 6 clips.
3. Disconnect the connectors, detach the clamp and remove the glove compartment door assembly.
REMOVE LUGGAGE DOOR OPENING CANCEL SWITCH ASSEMBLY
1. Detach the 2 claws and remove the luggage door opening cancel switch.

Text in Illustration
*1	Screw <A>
*2	Bolt <E>