REAR AIRBAG SENSOR REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  3. REMOVE REAR SEAT ASSEMBLY

    Click here

  4. REMOVE REAR DOOR SCUFF PLATE LH


    1. Place your hands on the inner portion of the rear door scuff plate LH and detach the 2 claws labeled A, 6 claws labeled B and 2 claws labeled C in the order shown in the illustration.

    2. Raise the rear door scuff plate LH to detach the 4 clips on the outer side and remove it.

      A01FDD4E01
      Text in Illustration
      *1 Claw A *2 Claw B
      *3 Claw C - -

  5. REMOVE REAR SEAT SIDE GARNISH LH

    A01FHYL

    1. Detach the 4 claws and guide and remove the rear seat side garnish LH.

  6. REMOVE REAR AIRBAG SENSOR LH


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Disconnect the connector from the rear airbag sensor LH.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. Push the housing lock and slide the outer housing. (At this time, the connector cannot be disconnected yet.)

        A01FFEQE11
        Text in Illustration
        *1 Housing Lock *2 Outer Housing

      2. Push the housing lock again and disconnect the connector.

        Note

        Do not push down the part (A) shown in the illustration when disconnecting.

    4. A01FEEX

      Remove the bolt and rear airbag sensor LH.

      Note

      Loosen the bolt while holding the rear airbag sensor LH because the rear airbag sensor pin (stopper) is easily damaged.