REAR SEAT SIDE AIRBAG ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. REMOVE REAR SEAT ASSEMBLY

    Click here

  3. REMOVE REAR SEAT AIRBAG ASSEMBLY LH

    CAUTION:

    When storing the rear seat side airbag assembly, keep the airbag deployment side facing upward.


    1. A01FIWE

      Remove the hog rings and fold back the part of the bench type rear seatback cover shown in the illustration.

    2. A01FEWP

      Remove the nut and disconnect the bracket of the bench type rear seatback cover.

    3. A01FFY2

      Detach the airbag connector from the frame of the bench type rear seatback pad.

    4. Remove the 2 nuts and rear seatback plate LH together with the rear seat airbag assembly.

    5. A01FDWR

      Detach the harness clamp.

    6. Remove the 2 nuts and rear seat airbag assembly from the rear seatback plate LH.

      Note

      The nuts must not be reused.