ELECTRICAL KEY OSCILLATOR (for Rear Floor) REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    A01FDQGE01

    1. Quickly lift up the front of the rear seat cushion assembly as shown in the illustration to detach the 2 rear seat cushion lock hooks.

      Standard Measurement
      a 100 mm (3.94 in.) or less

      Note

      If the cushion is not lifted up quickly, the cushion frame will be damaged.


      1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then quickly lift the bench type seat cushion assembly to detach the hook.

      2. Repeat the step above for the other hook.

    2. Detach the 2 rear hooks of the bench type rear seat cushion assembly from the bench type rear seatback assembly.

    3. A01FHVF

      w/ Seat Heater System:

      Disconnect the 2 seat cushion heater connectors.

    4. Remove the bench type rear seat cushion assembly.

      Note

      Be careful not to damage the vehicle body.

  4. REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    1. A01FDTW

      Using a clip remover, remove the 2 clips and pull back the floor carpet.

    2. A01FH0L

      Detach the claw and open the lid.

    3. A01FE6Y

      Connect the connector.

    4. Detach the 4 claws and remove the No. 2 indoor electrical key antenna.