MAYDAY SWITCH REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT ROOF TOP GARNISH


    1. Using a moulding remover, detach the 2 claws A.

    2. Using a moulding remover, detach the 2 clips A.

      Tech Tips

      When the 2 clips A are detached, claw B and guide B may also become detached.

    3. Detach the 2 clips B.

    4. Move the hooks of the 2 guides A forward, disconnect the connector, and remove the front roof garnish together with the map light assembly.

      Note

      w/ Lane Keeping Assist System:

      When removing and installing the front roof top garnish, do not apply force to the camera sensor located at (x).

      Tech Tips

      If the claw B and guide B do not become detached when the 2 clips labeled A are detached, detach claw B and guide B to remove the front roof top garnish together with the map light assembly.

      A01FDZUE01
      Text in Illustration
      *A for Standard *B w/ Lane Keeping Assist System
      *C w/ Rain Sensor - -
      *1 Claw A *2 Clip A
      *3 Claw B *4 Guide B
      *5 Clip B *6 Guide A

    5. Detach the 3 claws on the back of the front roof top garnish and map light assembly, and disconnect the front roof top garnish and map light assembly.

      A01FE47E01
      Text in Illustration
      *A for Standard *B w/ Lane Keeping Assist System
      *C w/ Rain Sensor - -

  4. REMOVE MAP LIGHT ASSEMBLY


    1. A01FFNC

      Using a moulding remover B, detach the 4 clips and 2 guides.

    2. Disconnect the 2 connectors and remove the map light assembly.